That’s all super helpful, thanks Josh!
I know there’s a lot of info out there about how to set up a dashboard, but it’s a bit daunting for an old guy like me. Appreciate you getting me pointed in the right direction. I think I “get” where this is all going now!
“Last” question for you, and I appreciate it’s a long way from an oven, so not sure if I should be tagging it onto this thread, but … any chance you could point me to a good post re: setting up a camera feed on SharptTools?
I’ve got TinyCam Pro running a webserver on my tablet and I can see the cameras on TinyCam, but I can’t seem to get the feed to show on SharpTools (tablet via Fully Kiosk or Chrome browser on desktop).
I’ve tried the steps at the below thread (tablet and browser), after clicking on the link that says “Failed to load image. Learn More”, but I still can’t seem to get it to work by allowing mixed content:
If I’m honest, though, I can’t quite figure out the webserver info vs. the camera info.
The webserver info in TinyCam shows: http://192.168.2.7X:8083/
The camera shows: http://192.168.2.11X:80/axis-cgi/mjpg/video.cgi?camera=1&showlength=1](http://192.168.2.11X/axis-cgi/mjpg/video.cgi?camera=1&showlength=1)
If I plug the camera info in my Chrome desktop browser, no issue seeing the feed.
But, in SharpTools, I’m using the following info based on this linked post and I get that error message above: Media and Thermostats - #13 by josh
http://192.168.2.7X:8083/axis-cgi/mjpg/video.cgi?camera=2 [and I’ve tried cycling through the camera numbers].
I feel like I’m close, but can’t seem to get this across the line. Anything obvious I’m missing?