MBMounts will ship overseas (it’s in their FAQ on their website)
I mentioned earlier - I got my 10" Flush Mount first and immediately discovered the aperture was too small for swiping; I’m waiting on replacement front acrylic bezel with an oversize opening (which Mike is providing at no charge!). When I ordered my surface mounts for the 7 & 8" I spec’d these to be 5mm larger than std in height/width (i.e. -2.5mm from original edge all way round) - I have recommended he adopt that as his standard as it does not detract any aesthetically and allows the true functionality for swiping from any direction. I don’t know if he has incorporated that as std or not at this point, so I would ask.
In another thread (on here I believe) someone had said the finish quality of the 3D print was poor - I would say quite the opposite, very happy with its appearance.You can obviously see the print seams on the inner surface, but the outside is very nice.
Here are my 7 & 8" Tablets in the MBMounts Surface Mounts (with the custom-spec’d apertures)
The Flush Mount is really nice too - it has an Acrylic Fascia that is held on simply by magnets (the back plate is 3D Printed and screws to the wall). Mine was customized to be extra-wide to cover up an old opening that housed a vintage Intercom system. Very slim and of course the Acrylic is a beautiful gloss vs the more-matte surface mounts. You can see my Acrylic Surface Mount further up this thread - just bear in mind that it is not normally that large vs a standard size wall mount